![Baker BP Dominator 3650E User Manual Download Page 55](http://html1.mh-extra.com/html/baker/bp-dominator-3650e/bp-dominator-3650e_user-manual_3504498055.webp)
55
Setting the Bullet Guides
(continued)
Follow the same instructions and procedure for the moveable guide.
Loosen the 1/4” bolts holding the bottom bullet guides and drop the bullets downward
then re-snug them so they don’t fall out.
Loosen the top bullets and pull them upward so they are not touching the blade.
Set the right (moveable) guide by loosening the top 1/4” bolt and drop the bullets to the
blade. Bullets should touch the blade
with gravity only
and then re-tighten the bolt.
Note:
Do not apply any down pressure.
Next the bottom bullets are ready to set.
Loosen the left guide 1/4” bolt and then bring the bottom bullets up to the blade and
apply a small amount of pressure to the blade. This will ensure a good snug fit to the
blade.
Retighten the 1/4” bolt holding the bullets up until the bolt is tight.
Repeat the same sequence for the right (moveable) guide.
Figure 53A
Figure 53
Loosen top and bottom
bullets so they are not
touching the blade, then
temporarily re-tighten
Loosen top bullets and drop
the blade and re-tighten
(Do not apply pressure!)
On the left guide, loosen and
bring the bullets up to the
blade with a light amount of
pressure, then re-tighten
On the right (moveable) guide,
loosen and bring the bullets up
to the blade with a light amount
of pressure, then re-tighten
Figure 52B
Loosen top and bottom
bullets so they are not
touching the blade, then
re-snug so they don’t
f ll t
Start by loosening the
bottom and top bullet
guides so they are not
touching the blade, then
re-snug so they don’t
fall out
Next loosen the top 1/4”
bolt and let the bullets
drop to the blade
Next loosen the top 1/4” bolt
and let the bullets drop to the
blade
(gravity only, apply no
pressure)
, then re-tighten
1/4” bolt
Start by loosening the
bottom and top bullet
guides so they are not
touching the blade, then
re-snug so they don’t
fall out
Figure 52B