19
Operator Control Station
Prior to cycling any controls, ensure the area is clear of personnel and obstructions. Make
certain anyone required to work near the mill is aware that the mill is in operation.
** It is the operator’s responsibilities to ensure these safety conditions exist **
Descriptions
•
Clamp In/Out
- Moves the clamp in and out.
•
Clamp Up/Down
- Raises and lowers the clamp
•
Toe Up/Down
- Raises and lowers the toe rollers.
•
Pac Man Up/Down
- Raises and lowers the log loader.
•
Log Deck Forward/Reverse
– Moves the (optional) Log Deck forward or reverse.
•
Head Forward/Reverse
- Locking valve that allows the head to travel forward or reverse. Valve will lock in the
forward position for unassisted saw head travel. Valve will not lock in the reverse position.
•
Turner Up/Down
- Raises or lowers the log turner.
•
Fence Up/Down
- Raises or lowers the fence arms.
•
Turner Forward/Reverse
- Rotates the log turner forward or reverse.
•
Saw Up/Down –
Raises and lowers saw head to desired height.
•
De-barker Switch
– (
optional feature
) Two position switch that controls the de-barker operation.
•
Setworks Reset – (optional feature)
Resets computer Setworks reference after turning log or loading a new log.
•
Setworks Joystick
- (
optional feature
) Four-position switch, Forward = Set 1; Back = Offset; Left = Guide In; Right
= Guide Out.
Note:
Only guide in and out functions are used on models without Setworks. See the optional
Computer Setworks Usage section for more information.
•
Head Speed Control
– Hydraulic flow control that sets the forward cutting motion speed of the saw carriage.
Note:
Effective cutting speed will vary depending on type of material being sawed.
Setting the Head forward speed too high can result in personal injury and/or equipment damage.
Always verify the head speed control valve position during daily mill inspection.
