31
Programming: (Cont.)
Reference Reset toggle switch located on the mill in
the operator’s main
Control station. Now the computer should display
“Scaling Point2” (See
Figure K
). Place the saw at its
highest point in whole inches (usually 32”) and enter
that number into the computer. At this time, flip the
Program/Run switch back to RUN and toggle
Reference Reset once more. It is possible to mess this
up enough to cause your computer to fail. If this
occurs, turn the computer off using the on/off switch
located on the bottom of your computer box. Then
switch the Program/Run switch to PROGRAM and
turn the computer back on. Go back into the scaling
portion of programming and enter a zero (0) for Point
One (See
Figure L
). Toggle Reference Reset twice and
the computer should say “Cycle Power Now” (See
Figure M
). Now, switch back to RUN and turn the
computer off. When the computer is turned back on, it
will be set to factory defaults. You will have to set the
scaling before operating your saw.
Figure K
Figure L
Figure M
