• Inspection
• Bolt (1) (overrunning clutch)
• Loosen then replace with new one and
apply fastening agent
CAUTION:
Fastening torgue of bolt (overrunning clutch) is
30Nm(3.0m·kg22yd·pound)
Apply the fastening agent on the bolt
19. Main clutch
Clutch case
1) Inspection:
• Clutch case assy (1) (inner surface)
Abrasion, wear, or damaged, replace it
• Single direction (2) (inside the clutch case
assy)
If scraped, worn, or damaged, replace it
2) Inspection the operation of single direction
clutch
Make sure that the inner spline cover (1) can
only rotate clockwise in direction A, if the inner
spline cover functions unsmoothly or rotates.
Counterclockwise, replace the inner spline
cover (1) and main clutch case assy (2) at
the same time.
Main clutch shoe
1) Inspection
• Clutch shoe
If abrasion is found, replace it
Wear limit of main clutch shoe: (a)
1.5mm (0.06 in)
2) Measurement
• Thickness of main clutch shoe
If out of specification, replace it.
20. Vice clutch
Clutch case
Inspection
• Split groove of clutch case
If there is pressing mark, worn, or damaged on
the groove face, remove the burr, or replace it.
175
Summary of Contents for WD250U
