Baja WD250U, Service Manual

Page: 225 / 232

3. Mount:
• Drive assy of rear wheel and rear wheel
fork
Assembly steps:
10 Lubricate following parts before mounting
the rear wheel fork
• Bearing (1)
• Oil sealing (2)
• Bushing (3)
• Coupling bolt of rear arm (4)
• Spline of drive shaft (5)
• Spline of main drive gear (6)
Lubrication oil:
Lithium base lubrication oil
2) Mount the drive shaft (7) on the spline (6)
of main drive gear.
3) Pull rear wheel fork forward and mount drive
shaft (7) on the rear joint of direction knot (8).
4. Connect:
• Rubber bushing etc. (1)
5. Mount:
• Coupling bolt (2) of rear arm
• Rear arm nut (3)
• Coupling bolt (4) of rear arm
CAUTION:
Turn the rear shaft bolt and rear arm shaft nut
temporarily, and don’t fasten them at this time.
6. Check:
• Operation of drive shaft
Checking steps:
• Hold the front wheel and put the proper
bracket on the frame for lifting rear wheel
• Front and rear turning wheel
• Check the operation of driving shaft. If the
operation is not good, check the installation of
drive shaft again
223