Take off bearing (3) with usually bearing tool.
The reverse step of “bearing and oil sealing
replacing step” is the mounting step of new
bearing and new oil sealing.
CAUTION:
Use a pressure tooling (4) which is matched
with outer diameter of bearing race (7) and
oil sealing.
WARNING:
Don’t strike the bearing inner race (5) and
roller. The pressure tooling (4) is only in
contact with outer race (7) .
(III) Mounting steps:
The reverse step of “disassembly” is the
mounting step, but the following points must
be paid attention to during the installation:
1. Lubricate the bearing (10, oil sealing (2)),
bush (3) , and rear arm joint bolt (4) .
Lubrication oil is Lithium base grease.
2. Mount the real wheel fork assy, rear wheel
fork bushing and rear arm joint bolt.
112
Summary of Contents for WD250U
