background image

Instruction Rev00

0

mm

10

20

30

40

50

60

70

80

90

Thank you for choosing DENALI

We know you would rather be riding your bike than wrenching on it, so we go the extra 
mile to make sure our instructions are clear and as easy to understand as possible. If 
you have any questions, comments, or suggestions don’t hesitate to give our experts 
a call at 401.360.2550 or visit WWW.DENALIELECTRONICS.COM

Please Read Before Installing 

DENALI products should always be installed by a qualified motorcycle technician. If 
you are unsure of your ability to properly install a product, please have the product 
installed by your local motorcycle dealer. DENALI takes no responsibility for damages 
caused by improper installation. 

Caution:

 When installing electronics it is extremely 

important to pay close attention to how wires are routed, especially when mounting 
products to the front fender, front fork, or fairing of your motorcycle. Always be sure 
to turn the handlebars fully left, fully right, and fully compress the suspension to 
ensure the wires will not bind and have enough slack for your motorcycle to operate 
properly.
 
   

Installation Tips

We strongly recommend using medium strength liquid thread locker on all screws and 
bolts. It is also important to ensure that all hardware is tightened to the proper torque 
specifications as listed in your owner’s manual. For included accessory hardware 
please refer to the default torque specifications provided below. Inspect all hardware 
after the first 30 miles to ensure that proper torque specifications are maintained.  

Hardware Sizing Guide

Not sure what size bolt you have? Use this ruler to measure screws, bolts, spacers, etc. 
Remember, the length of a screw or bolt is measured from the start of the “mounting 
surface” to the end of the screw, so only include the screw head when measuring 
countersunk screws.  

M3

10.0 in-lbs

-

1.0 Nm

M4

23.0 in-lbs

-

2.5 Nm

M5

44.5 in-lbs

3.5 ft-lbs

5.0 Nm

M6

78.0 in-lbs

6.5 ft-lbs

9.0 Nm

M8

-

13.5 ft-lbs

18.0 Nm

M10

-

30.0 ft-lbs

41.0 Nm

M12

-

52.0 ft-lbs

71.0 Nm

in-lbs

ft-lbs

Nm

Bolt Size

0

in

1

2

3

What’s In The Box?

DENALIELECTRONICS.COM

Instruction Manual

(a) DialDim™ Wiring Harness.....................................................Qty 1

DialDim™ Wiring Harness

Kawasaki KLR650

DNL.WHS.21900

OUTFITTING
GUIDE

Reviews: