Baja WD250U, Service Manual

Page: 47 / 232

(IV) Position adjustment of steering lever
• Position adjusting procedure of steering lever.
• Place the vehicle on level ground.
• Change gears to 1st gear and pull the steering
lever (1) to reverse gear position.
• Loosen the locking nut (2)
• Screw in or out the adjusting nut (3) of steering
lever until the middle line (a) of the tension rod
plate aims at the alignment mark (b) on the rear
transmission cover (or the vehicle will not release
the gear).
• Screw tightly lock nut (2)
Torsion of lock nut: 15N·m
CAUTION:
After adjusting the steering lever, ensure the re -
verse gear indicator lights up when the steering
lever is in the reverse position.
(V) Lubricating oil level inspection of rear driving
gear case.
Check the lubricating oil level of the gear case.
CAUTION:
The engine must be in a cold state
Checking procedure:
• Place the vehicle on level ground.
• Placce oil catcher under the gear case.
• Remove the oil filling screw plug (1) and sealing
washer.
• Observe the oil level: the correct amount should
be on the bottom of oil filling hole.
• If the oil level is too low, refill the recommened
engine oil to specified oil level.
Refer to the section “replacement of engine oil of
rear driving gear case”.
• Check for any damages to the sealing washer, if
damaged replace it.
• Install the sealing washer and oil fill screw plug
(1).
CAUTION:
• Install the sealing washer before installing the oil
filling screw plug.
• After installing the oil fill screw plug, check for
leaks.
Torsion of oil fill screw plug: 23N·m
1
a
b
4
1
2
3 4
47