![background image](http://html.mh-extra.com/html/bailey/infi-90-iiois12/infi-90-iiois12_hardware-manual_467121127.webp)
INSTALLING SOFTWARE
INSTALLING OIS12 SOFTWARE (SOFTWARE RELEASE 5.1A or 5.2)
A - 20
I-E96-107-2N
®
Installation of Security Key
Included with your OIS12 software is a SentinalC-plus Secu-
rity Key attached to the parallel port of the console. This device
is used to identify registered copies of OIS12. Without the key,
a pop-up window will appear once every five minutes declaring
the software to be unregistered.
To install the security key, simply attach the key to the parallel
port 25 pin DIN connector at the rear of the computer. The
port selected must be configured as LPT1. Tighten the
thumb-screws to secure the key and connect the printer to the
key. The SentinelC-plus security key is a passive device which
allows the parallel port to function normally.
Installation
STEP 1
Booting from Disk
Reboot using the following steps:
Remove any floppy disks from the drives.
Press
<Ctrl Alt Shift Del>
Login:
root
STEP 2
Setting Configuration Options
Insert the pcvInstall disk in the first floppy drive.
Type:
install
You now will see the Introduction screen (Figure
Answer
No
ONLY if this is the only computer running OIS12
software or you will not be networking these computers (Fig-
ures
Only answer
Yes
on one machine. See
above.
CAUTION
Do not press <Esc> unless you want to abort the installation.
After aborting, you will need to re-install QNX and OIS12 soft-
ware so that the software is correctly installed.
CAUTION
Before installing or removing the security key, the computer
MUST
be turned off and proper anti-static safety precautions
must be followed.
Before connecting or disconnecting a printer to the security
key, the printer
MUST
be turned off.