INTRODUCTION
IIOIC12 HARDWARE OVERVIEW
1 - 4
I-E96-107-2N
®
•
Ethernet Network Card.
•
One 32-key ADP panel.
•
One parallel port.
•
One serial port (COM1).
•
One mouse.
•
Operator mylar style keyboard with 16 user-defined keys.
•
Serial interface card (2-port) (CTI Intellicon-2).
•
Engineering (AT style) keyboard.
The OIS12 console hardware is located in the operator console
cabinet. The power entry panel, computer and multibus card
cage are in the lower half of the cabinet. The CRT and operator
keyboard interface panel with the 3.5-inches diskette drive are
located in the upper half of the cabinet.
The keyboard interface panel is located beside the CRT on the
front of the cabinet. It is made up of the diskette drive and con-
nections for the operator OIS keyboard, mouse and an engi-
neering keyboard. Refer to
for the installation
dimensions. Refer to
for the layout of the multibus
chassis, computer and the power entry panel.
IIOIC12 HARDWARE OVERVIEW
The IIOIC12 is a “slave” node which provides a remote operator
interface for display graphics, alarm summaries, INFI 90 OPEN
status, logs, trends and control stations. The OIC allows more
than one operator to use a single “master” OIS.
The IIOIC12 is networked to the IIOIS12 “master” through a
Network card and cable between the OIS master and the OIC
slave.
Refer to Figure
for the communication layout.
IIOIC12 Console Hardware
The CRT, and I/O panel for the keyboard are in the upper sec-
tion of the console cabinet. The lower section of the cabinet
contains the computer, power entry panel and multibus key-
board controller card.
The IIOIC12 console cabinet contains:
•
1.44 megabytes 3.5-inches floppy disk drive.
