Bailey Infi 90 IIOIS12, Hardware Manual

Page: 72 / 172

INTRODUCTION
I-E96-107-2N 5 - 1
SECTION 5 - IIOIC12 HARDWARE
INTRODUCTION
This section describes the standard and optional hardware
used by the IIOIC12 operator interface console. Each entry
contains jumper and switch configurations for the particular
component.
NOTE: The components in the OIC are configured at the factory.
Settings shown in this section have already been made. This infor-
mation is given in case settings are changed or hardware needs to
be replaced.
The location of components and the wire and cable connec-
tions are also given. This information is a reference for stan-
dard and optional equipment.
IIOIC12 HARDWARE
NOTE: See also Appendix B .
Standard hardware in the OIC consists of the multibus mylar
keyboard card, computer, operator interface equipment and
power entry panel.
Table 5-1 lists the standard hardware used in the operator
interface console. Table 5-2 lists the optional hardware that
can be used.
IIOIC12 CONSOLE COMPONENT LOCATIONS
IIOIC12 console hardware is located in the operator console
cabinet. The power entry panel, computer, 3.5-inch disk drive
and the IIMKM01 card are in the lower half of the cabinet. The
Table 5-1. Standard OIC Hardware
Nomenclature Description
1948623A6/A9 Colour monitor.
6638353A_
6638554A_
6639514A_ Power entry panel.
Keyboard interface panel.
Operator mylar keyboard assembly.
IIADP02 ADP panel.
IIMKM01 Multibus keyboard module.
L700796_13 Computer with an Intel 66 MHz, 32-bit 486
DX processor (minimum).
L750067B2 Ethernet card.