INTRODUCTION
STANDARD AND OPTIONAL HARDWARE
I-E96-107-2N
1 - 5
•
16 megabytes (minimum) of dynamic RAM memory.
•
19-inches colour CRT (1024 x 768 pixel resolution).
•
66 MHz, 32-bit Intel 486 DX processor (minimum) with
built-in math coprocessor.
•
IDE hard disk drive (not included in early versions).
•
Battery-backed real-time clock.
•
Graphics processor card.
•
Ethernet Network card.
•
One 32-key ADP panel.
•
One parallel port.
•
Two serial ports.
•
One mouse.
•
Operator keyboard with 16 user-defined keys.
•
Engineering (AT style) keyboard.
OIC12 console hardware is located in the operator console cab-
inet. The power entry panel, computer, and the multibus key-
board controller card are in the lower half of the cabinet. The
CRT and operator keyboard interface panel are located in the
upper half of the cabinet. The 3.5-inches diskette drive is
located in the computer.
The keyboard interface panel is located beside the CRT on the
front of the cabinet. It is made up of the connections for the
operator OIS keyboard, mouse and engineering keyboard.
Refer to
for the installation dimensions. Refer to
for the layout of the IIOIC12 hardware.
STANDARD AND OPTIONAL HARDWARE
NOTE: See also
Table
lists the hardware used in the Operator Interface
Station (OIS) and Operator Interface Console (OIC). The
optional hardware is listed in Table
.
