IIOIS12 HARDWARE
MULTIBUS CHASSIS HARDWARE
4 - 6
I-E96-107-2N
®
Multibus Module Removal
Remove the modules by pulling the removal tabs on the ends
of the card toward you and gently sliding the module out of the
chassis. Be sure not to loosen cables from the modules next to
the one you are removing.
Multibus Loop Module
•
Elsag Bailey Nomenclature - IIMLM01.
The Multibus Loop Module, shown in Figure
, allows com-
munication between the Multibus Communication Processor
Module (IIMCP01) and the INFI-NET or Plant Loop communi-
cation highway through the termination module (IIMCL01).
Refer to Table
for jumper and dipswitch settings. Use two
ribbon cables numbered 6634512_26N2 to connect the loop
module to the communication processor and to the termina-
tion module.
NOTE: Dipswitch SW1 and SW2 selects the loop address and ring
number of this OIS and depends on your individual system.
CAUTION
Failure to turn off the main power circuit breaker before remov-
ing or inserting modules into the chassis may result in equip-
ment failure.
Figure 4-5. Removing Multibus Chassis Cards
GS950605
PULL
REMOVAL TABS
SIDE VIEW OF MODULE
PULL
CAUTION
Failure to turn off the main power circuit breaker before remov-
ing or inserting modules into the chassis may result in equip-
ment failure.
