Baileigh STS-14120DRO, Operator'S Manual

Page: 33 / 116

29
29
RIP FENCE ASSEMBLY
Install the screw on the round rod into the right side of the working table, put into the rip 1.
fence base, adjust three nuts on the round rod to make rip fence parallel to the saw blade.
Use the gauge to measure the parallelism of the rip fence and the main saw blade. 2.
Measuring: The rip fence is stationary and the sliding table is pushed to the left. Measured
tolerance is 0 ~ 0.003” (0 ~ 0.1mm) from the left to the right as the direction shown in the
above drawing. Parallelism of the sliding table and the main saw blade must be adjusted
within tolerance before proceeding.
Adjust the eccentric wheel on the front end of the fence base to make the fence base parallel 3.
to the working table.
Adjust two eccentric wheels at the side of the fence 4.
base to make the aluminum fence parallel to the
working table.
Tighten the rip scale. Adjust the limit screw on the stop 5.
block. The safe gap between the fence and the saw
blade is at 0.5mm.
The screw at the left side is the limit for cutting 90°. 6.
The screw at the right side is the limit for cutting angle. 7.
L
R