Baileigh STS-14120DRO, Operator'S Manual

Page: 31 / 116

27
27
CROSSCUT FENCE ASSEMBLY
The crosscut fence may be mounted in either the near or far set of mountings points on the
crosscut table, or it may be removed from the table.
This instruction specifically installs the crosscut fence in the far set of mounting points and uses
the near set as indicators.
Note If the crosscut fence is removed, or moved to the opposite mounting point,
check and adjust (if needed) the perpendicularity of fence to the saw blade before use.
Place the crosscut fence onto the 1.
crosscut table so that the triangular
support (A) is away from the main
table and the locating pins into the
positioning points (B) and (C) of the
crosscut table.
Lift the lock handles (D) and slide 2.
them inward to the fully unlocked
position.
Set the locating pins of the crosscut 3.
fence into the locating holes and slide
the lock handles outward and rotate
them down to lock the crosscut fence to the crosscut table.
After the machine is completely set-up and assembled, Check and adjust the perpendicurity 4.
of the crosscut fence to the saw blade.
Crosscut Fence Adjustment
Raise the main blade to full height. 1.
Disconnect and lockout power to the 2.
saw!
Plac
e a carpenter’s square across the
3.
face of the blade and carefully slide it
against the crosscut fence.
There should be no gap between the
square and the crosscut fence.
A
B
C
D
D