Baileigh STS-14120DRO, Operator'S Manual

Page: 28 / 116

24
24
Install the table lock (E) onto the right end of the 11.
sliding table using the M6 x 20 screw, washer, and
M6 nut (F).
The lock can fasten the sliding table in the middle and 12.
the end positions.
Before the sliding table is moved, make sure the 13.
safety lock is unlocked.
Lifting the handle will lock the table. 14.
Pressing down on the handle will unlock the table. 15.
The front handle is moveable on the front rail of the 16.
slide table. Install the front handle over the rail and
posioion near the end. Tighten the hand screw to
hold in position. This handle may be position along
the rail as desired or removed as needed.
Install the end caps on the ends of the slide table. 17.
Remove the bolts from the slide table and insert the
bolts through the end cap brackets and tighten. The
end cap with the handle go on the right end of the
sliding table.
LENGTH EXTENSION TABLE INSTALLATION
Loosen the 3 extension table mounting bolts (A) on 1.
the main table just enough to slide the extension
table onto them.
Slide the extension table onto the mounting bolts so 2.
that the extension is tight to the main table and the
washers and bolt heads (A) are to the inside of the
extension table.
Place a level across the extension table and the 3.
main table.
Adjust the leveling bolts (B) to level the extension 4.
table to the main table.
When the extension table is level to the main table, tighten the mounting bolts (A) keeping 5.
the extension table level and and flush to the main table.
E
F
A
B