Baileigh STS-14120DRO, Operator'S Manual

Page: 44 / 116

40
40
CHANGE SCORING SAW BLADE
Disconnect and lockout power to the saw! 1.
Push the sliding table to the left until the travel release 2.
rod (A) is exposed.
Push the ball on the rod inwards to release the sliding 3.
table to allow it to over travel the bed and expose the
blade housing.
Pull forward on the saw blade guard to open it. 4.
Use the wrench provided to hold the arbor and 5.
remove the flange nut.
Make sure the new saw and flange are clean. 6.
Install the new saw blade and torque the nut to 20 lb/ft 7.
(250kg/cm) to tighten the arbor nut.
Close the saw cover. 8.
Move the slide table back to the right to engage the 9.
travel limit rod.
Important: The scoring saw blade flange
nut must be torqued to 20 lb/ft (250kg/cm).
The shims are used to adjust the cutting width of the
scoring saw to allow it to be wider than the cutting width
of the main saw blade to make the cutting workpiece look
nicer.

Thickness of the scoring saw is 2.8mm. Adding shims
in combination will increase the thickness of the
scoring saw blade up to 4.3mm.

Shim size & quantity:
0.1mm 1pcs.
0.2mm 1pcs.
0.3mm 4pcs.
WARNING:
Blades are dangerously sharp. Use extreme caution when
working with or around the blade. Wear proper safety protection such as heavy
gloves.
Turn the power
switch “OFF” and unplug the power cord from its power source when
changing the saw blade.
A