Baileigh STS-14120DRO, Operator'S Manual

Page: 29 / 116

25
25
WIDTH CUTTING EXTENSION TABLE INSTALLATION
Locate the two extension table supports. 1.
Remove the 4 cabinet mounting bolts (A) from the 2.
back of the main cabinet and install the supports
with the leveling bolt (B) up and the adjustment
opening toward the outside.
Tighten the cabinet mounting bolts (A) enough to 3.
hold the supports stable but allow a little movement
for alignment of the leveling bolt locating bolts (D) to
the extension table.
Loosen the 4 extension table mounting bolts (C) on 4.
the back of the main table just enough to slide the
extension table onto them.
Slide the extension table onto the mounting bolts so 5.
that the extension is tight to the main table and the
washers and bolt heads (C) are to the inside of the
extension table.
Install the leveling bolt locating bolts (D) into the 6.
extension table 3
– 4 turns.
Align the extension table supports and final tighten 7.
the mounting bolts (A).
Place a level across the extension table and the 8.
main table.
Adjust the leveling bolts (B) on the supports to level the extension table to the main table. 9.
When the extension table is level to the main table, secure the table starting with the 4 bolts 10.
(C) securing the extension to the main table keeping the table level and and flush to the main
table.
Fine tune the extension table level as needed and then tighten the upper and lower leveling 11.
bolt (B) jam nuts.
Tighten the leveling bolt locating bolts (D). 12.
A
B
C
A
C
B
B
D