Baileigh Industrial BS-330SA, Operator'S Manual

Page: 49 / 76

46
46
Hydraulic Vise Clamping Pressure Adjustment
The pressure is preset to 25kgs in the factory for cutting solid steel bar.
If cutting a pipe with a thin wall, the pressure should be
adjusted to 15kgs (even though the pressure gauge (B)
reads from 0 to 100kgs, the general usable range is from 15-
30kgs.)
The adjustment proceeds as follows:
1. Disconnect the machine from the power source.
2. Open the cover (A) of the electronic pressure control by
using a screwdriver.
3. Reduce the pressure by using a screwdriver to turn the
pressure screw counterclockwise a little bit (1/8 to 1/4
turn).
4. Connect machine to the power source.
5. Load a solid steel bar between the vise jaws and use one
hand to push the movable vise toward the work piece
against the fixed jaw.
6. Press the start button and check that the gauge reads the
desired clamping pressure.
7. If not, readjust the pressure by following the step 3 to 5
again till the proper pressure is obtained.