Baileigh Industrial BS-330SA, Operator'S Manual

Page: 45 / 76

42
42
Broken-blade Shut-off Switch
This machine is equipped with automatic power shut-off safety device to prevent any further
damage when a blade has broken.
After replacing a new blade, the safety device may need to be readjusted. If the power indicator
light is not on when power is turned on, the shut-off switch
has not been properly set.
To adjust, follow these steps:
1. Disconnect the machine from the power source.
2. Loosen the two set screws (C) to release the limit switch.
3. Move the limit switch toward the block plate (B) and make
sure the trigger button (A) of the limit switch is near the
block plate.
4. Press the start button to see whether the power indicator
light turns on. If not, readjust again.
Changing Blades
1. Raise the saw arm approximately 6” (150mm). Press the
emergency stop to hold the arm in place.
2. Disconnect machine from power source.
3. Open the blade cover, locking it securely on the blade
cover latch.
4. Clean chips out of both wheel housings.
5. Loosen lock knobs and remove upper and lower blade
guard.
6. Remove wire brush assembly.
WARNING:
Disconnect the machine from the power source before
making any adjustments or repairs! Failure to comply may result in serious injury!