Baileigh Industrial BS-330SA, Operator'S Manual

Page: 47 / 76

44
44
Blade Tracking Adjustment
Blade tracking has been set at the factory and should require no adjustment. If a tracking
problem occurs, adjust the machine as follows:
Since tracking can only be adjusted while machine is running, it is suggested that this
adjustment be accomplished by qualified personnel that are familiar with this type of adjustment
and the dangers associated with it.
1. Start the saw hydraulics.
2. Raise saw arm to its highest position.
3. Open the blade covers to observe the blade tracking
on the wheels.
4. Locate tracking adjustment plate on the back side of
the idle wheel.
5. Loosen the three bolts (A) located on the top of the
tacking nuts.
6. Tracking adjustment is accomplished by either
loosening or tightening three adjusting nuts (B).
7. Tracking is set properly when the back of the blade lightly touches the wheel flange.
Note: Over-tracking (allowing blade back to rub hard against wheel flange) will
damage the blade wheels and blade.
8. Tighten locking bolts (A) once proper tracking is completed.
9. Close the blade covers.
WARNING:
Tracking adjustment is done with the wheel cover open to
observe the blade. Use extreme caution so as not to come into contact with the
blade! This adjustment must be accomplished by qualified personnel that are familiar
with this type of adjustment and the dangers associated with it. Failure to comply
may result in serious injury!