Baileigh Industrial BS-330SA, Operator'S Manual

Page: 51 / 76

48
48
Monthly
•
Check the tightness of the drive wheel screws.
•
Check that the blade guide bearings on the heads are in perfect running condition.
•
Check the tightness of the screws for the motor, pump, and accident protection guards.
Lubrication
AII ball bearings are permanently lubricated and sealed. They require no further lubrication.
Replacing the Coolant
1. Disconnect the machine from the power source.
2. Remove the drain plug (A) with a hex wrench and allow
coolant to drain completely.
3. Remove the hex cap bolt (B) and move the pump unit
(D) away.
4. Clean the drain screens on the machine base and the
drains on the ends of the table.
a. Drain and wash out the dirt and debris from the
reservoir.
b. Vacuum out the chips and debris from the tank.
5. Replace the drain plug (A).
6. Add coolant to the highest level of the coolant sight gauge (C).
7. Replace the pump unit (D) and fasten the bolt (B).
Oils for Lubricating Coolant
Any 10:1 (water to coolant) solution will work, however we recommend Baileigh B-Cool 20:1
(water to coolant) biodegradable metal cutting fluid. It has excellent cooling and heat transfer
characteristics, is non-flammable, and extends tool and machine life. Each gallon of concentrate
makes 21 gallons of coolant.
A
C
B
D
E