Baileigh Industrial BS-330SA, Operator'S Manual

Page: 40 / 76

37
37
Cutting Limit Switch Adjustment
When making multiple cuts of the same size stock, the band saw can be made to cut more
efficiently by setting the saw arm's return height based
upon the material to be cut. For Example, cutting 4"
(102mm) thick material, the saw arm can be preset to
be raised to only 5" (127mm) in height before making
the next cut.
1. Place the saw arm to the horizontal position.
2. Release the limit switch (B) by loosening the handle
(E).
3. Use the scale (A) to set the desired measurement of
the saw arm raising position.
4. Tighten the handle (E). Do not overtighten the
handle.
5. If the saw does not stop automatically after a
complete cut, the micro switch (C) needs to be
adjusted.
6. To release the set position, the procedure is the
same but move the limit switch to maximum level.
Automatic Shut-Off
The blade will stop after the material has been cut and the bow reaches its lowest position. The
bow will then automatically rise to its preset height.
Note: If the bow or blade fails to stop, the limit switch (C) must be raised.
1. Loosen 2 screws (D).
2. Lift limit switch to desire height.
3. Tighten 2 screws (D).
A
C
D