PT-6IL
MAINBOARD
INTRODUCTION
ii
SOMETHING IMPORTANT !
¶
TRADEMARKS
All trademarks used in this manual are the property of their respective owners.
¶
LOAD SETUP DEFAULTS
“LOAD SETUP DEFAULTS” is the function which will have the BIOS default
settings loaded into the CMOS memory, these default settings are the best-case
values that should optimize system performance and increase system stability .This
function will be necessitated when you receive this mainboard, or when the system
CMOS data is corrupted. Please refer to the page 5-12 for executing procedures.
¶
DISCHARAGE CMOS DATA
Whenever you want to discharage the CMOS data or open the system chassis, Make
sure to disconnect the AC power first because there is always the 5V standby voltage
connected to the ATX form-factor mainboard. Without disconnecting the AC power
connector from the PC system, the mainboard may be damaged by any incorrect
action . Please refer to the page 4-16 for executing procedures.
¶
WAKE ON LAN
In order to support the Wake On LAN feature, the system requires a special SPS
(switching power supply), Such power supply must be able to provide at least 700
mA of driving capability on the “5V standby” voltage. Please refer to the page 4-12
for pin asignment.
¶
WARNING !
The "Static Electricity" may cause damage to the components on the mainboard, In
order to avoide the damage to the mainboard accidentally, please discharge all static
electricity from your body before touching this mainboard.
¶
NOTICE
Information presented in this manual has been carefully checked for reliability;
however, no responsibility is assumed for inaccuracies. The information contained in
this manual is subject to change without notice.
