PT-6IL
MAINBOARD
INSTALLATION
3
When you have a PS/2™ mouse connected to the system, you may change the setup
in the BIOS and use the mouse click to turn on the PC system power. It is so simple,
convenient and welcomed by children. Please refer to page 4-101 and page 4-11 for
the BIOS settings
To use the mouse key to turn on the PC system power, the mouse click must be
done quickly and continually. Basically, 2-5 quick clicks on the mouse key will turn
the power immediately.
In order to activate the mouse key feature, you will have to reboot the PC system
after the BIOS setting and wait until the POST (Power On Self Test) is completed.
Having finished the procedure, you may use the mouse key to power-on the PC
system afterward..
Note: This feature is not available on the COM (serial) port mouse.
¨
RTC ALARM
PC system can be waked up by the RTC setting in the CMOS. You can set the
alarming date and time in the RTC memory, When RTC alarms, the PC system will
be triggered and wakes up automatically.
Enable the “Resume by Alarm” selection in the BIOS setup utility, and then input
the accurate date and time in following fields. (the “Resume by Alarm” is located in
the “POWER MANAGEMENT SETUP”, please refer to page 4-8 and page 4-9 for
detail procedures), Having stored the RTC alarm setting, the PC system will be
turned on automatically according to the date and time which is recorded in the
CMOS memory.
Same as the above, you have to reboot the PC system and wait for the POST (Power
On Self Test) is completed to enable the RTC alarm.
¨
MODEM RING-IN
Everyone knows that a PC system can be used as a fax machine to send or receive
fax messages. But most people still use fax machine to receive their messages
because it is not practical to have the system powered on all day long waiting for the
incoming messages. Now the problem can be solved by using the PT-6IL
mainboard. PT-6IL can be triggered by a modem ring-in signal. When you have a
external modem installed, you can leave the PC system power off. Whenever there
