PT-6IL
MAINBOARD
HARDWARE SETUP
8
Retention mechanism
Large peg
and hole
3.
Slide a black plastic support ( active heat sink support ) to each end of fan heat
sink. Make sure that the hole and clip are on the outside edge of the support. (If the
supports are reversed, the holes will not line up with the pegs on the mainboard.)
Slide each support toward the center of the processor until the support is seated in
the outside groove in the fan housing.
Top of processor
Hole and clip
on outside edge
Groove in fan housing
4.
Slide the clip (A) on each support toward the processor, exposing the hole that will
fit over the peg on the mainboard. Push the latches (B) on the processor toward the
center of the processor until they click into place.
5.
Hold the processor so that the fan shroud is facing toward the pegs on the
mainboard. Slide the processor (C) into the Retention Mechanism and slide the
supports onto the pegs. Ensure that the pegs on the mainboard slide into the holes in
