PT-6IL
MAINBOARD
INSTALLATION
4
is the incoming message, the PC system will be triggered by the ring-in signal and
wake up automatically to receive the message for you. From now on, you can tell
your PC system to receive the fax message for you.
In order to use the ring-in signal to wake up your PC system, you will have to use the
EXTERNAL MODEM
and have it connected to one of the
SERIAL PORTS
( COMA or COM B ). When the system power is off, PT-6IL will continue to detect
the serial port status. When it detects the ring-in signal, the system power will be
turned on and start to receive the incoming messages automatically. ( you may need
to have the software like Award Zero-Volt Data-Suspend Utility so that you can use
the fax utility to receive the incoming fax message ).
To enable the Modem Ring-In feature, you will have to use the BIOS setup utility
and enable the “Resume by Ring or LAN” option (it is located in the “POWER
MANAGEMENT SETUP”, please refer to page 4-8 and page 4-9
for the settings).
Having completed the BIOS setup, you have to reboot the PC system so that BIOS
can verify the setting. ( the “DMI pool data” will be verified by the BIOS when
loading the operating system). Simply speaking, shut down the PC system and
reboot the system. The modem ring-in feature will be enabled when the operation
system has been loaded.
Note: This function is unavailable when using the internal MODEM card.
¨
WAKE ON LAN ( WOL )
There is a WOL connector (CN14, please refer to page 3-24 for the pin assignment
of WOL connector) on the mainboard which is designed onboard to connect to the
signal from a LAN card that supports a Wake On LAN feature. When such LAN
card is installed, you may turn on the PC system from your remote server and
monitor the PC status.
To enable this feature, you will have to use the BIOS setup utility to enable the
“Resume by Ring or LAN” (it is located at “POWER MANAGEMENT SETUP”,
please refer to page 4-8 and page 4-9 for the settings). Having completed the BIOS
setup, you have to reboot the PC system so that BIOS can verify the setting. ( the
“DMI pool data” will be verified by the BIOS when loading the operating system).
Simply speaking, reboot the PC system, the Wake On LAN feature will be enabled
when the operation system has been loaded
