Avery Dennison SNAP 700, Operator'S And Service Manual

Page: 19 / 153

User’s Manual—SNAP™ 700 Printer
19
2.5.3 Installing the Power Cord
A quick-disconnect power cord is shipped with each 115V printer. The cord for
115V printers will use the standard three-prong plug used in the U.S.A.
If a power cord is not supplied with your printer, and your printer is operating at a
rating other than 115V, you will need to obtain a power cord for your voltage
application. The power cord should have an IEC-320-C13 plug on one end and
the appropriate plug for your power receptacle at the other end.
1. Locate the AC power entry receptacle on the backside of the printer just
below the power switch (see Figure 5).
2. Plug the power cord into the AC power entry receptacle.
2.5.4 Installing the PC Interface Cable
If you will be using your SNAP 700 printers with a personal computer, one of the
following computer interface cables is required:
•
Null-modem serial cable with Part number 581139 connector
•
USB / Serial adapter – Part number 581140
•
Ethernet adapter – Part number 05591105
1. Locate the communication cable connectors on the backside of the printer
(see Figure 6).
2. Plug in the serial cable connection to the serial port.
The default serial port configuration is 115,200 baud, no parity, 8 data bits, 1 stop
bit.
Figure 6. Rear View of the Printer
115V Fuse Line Voltage
Power
Switch
AC Connection for Power
Serial Port for Communication to