![background image](http://html.mh-extra.com/html/avery-dennison/adtp1-monarchnet2/adtp1-monarchnet2_operating-instructions-manual_3030311009.webp)
Using a Web Browser2-3
C o n f i g u ri n g t h e P r i n t e r
You can configure the printer using your Web browser.
1.
From the side Menu Bar, click
Printer Configuration
.
2.
Select one of the following tabs:
Printer Setup
or
Supply Setup
.
Changing the Printer Se tup
Only configure the settings required for your network/printer.
Note:
Only the available options for your printer are displayed.
1.
On the
Printer Setup
tab, set the
Ribbon
: None, Ribbon, or High Energy.
2.
Set the
Supply Type
: Edge Aperture, Edge Die Cut, Edge Black Mark, Continuous, Center
Aperture, Center Die Cut, or Center Black Mark.
3.
Set the
Feed Mode
: Continuous, On Demand, or Liner take-up (optional).
4.
Enter a value for the
Cut Adjust
(Position). The range is –300 to 300. This adjusts where the
tag is cut.
5.
Enter a value for the
Supply Position
. The range is –300 to 300. This adjusts the printer to
print at the vertical 0,0 point. Only adjust on initial printer setup.
6.
Set the
Batch Separators
: No, Yes, or Long.
7.
Set the
Skip Index
mode: No or Yes. Skip index allows you to print an image over multiple
labels.
8.
Set the
Backfeed
: Off, On, or Extended. Backfeed advances each printed label to the specified
dispense position and then backs up the next label to be printed underneath the printhead.
Do
not use extended backfeed on printers without a cutter.
9.
Enter a value for the
Dispense Position
(range is 50 to 200). This adjusts the stopping point of
the label
after
it is printed.
10.
Enter a value for the
Backfeed Distance
(range is 20 to 200). This is the amount to move the
label backwards
before
printing.
Summary of Contents for ADTP1 MonarchNet2
