![background image](http://html.mh-extra.com/html/avery-dennison/adtp1-monarchnet2/adtp1-monarchnet2_operating-instructions-manual_3030311014.webp)
2-8 MonarchNet2 Operating Instructions
Changing Wireles s Settings
Only configure the settings required for your network/printer.
1.
Click the
Wireless
tab to configure the wireless network (802.11a/b/g/n) settings.
2.
Set the
Mode
: Ad-Hoc or infrastructure. In Ad-Hoc mode, you do not need an access point.
Infrastructure mode requires an access point to communicate.
3.
Set the
SSID
. The SSID is a unique identifier that must match for all nodes on a subnetwork to
communicate with each other.
4.
Set the
Regulatory Domain
, which is the country of use.
5.
Set the
Roam Hysteresis
. The range is 1 – 15. W henever the printer’s signal strength gets
below this value, the printer connects to another access point in range with better signal
strength. This prevents excessive roaming between access points if the printer is located near
two access points.
6.
Set the
Encryption Mode
: Disable, 64 BIT Encryption, 128 BIT Encryption, W PA, W PA2, W PA2-
WPA, and DYNAMIC WEP. The encryption mode determines the algorithm used to encrypt
messages.
7.
Set the
Authentication Type
: Open, Shared, TLS, TTLS, LEAP, PEAP, or EAP-FAST. The
authentication type specifies how users are identified and verified on a network. These options
vary depending on what was selected as the Encryption Mode. See “
Basic Security
Configurations
” for more information.
8.
Set the
Authentication Protocol
: PAP, or MSCHAP_V2. See “
Basic Security Configurations
”
for more information.
9.
Enter the
User ID
.
Summary of Contents for ADTP1 MonarchNet2
