Using a Web Browser2-7
Changing SNMP S ettings
Only configure the settings required for your network/printer.
1.
Click the
SNMP
tab to change SNMP settings.
2.
Enter the
System Name
, if it does not automatically appear.
3.
Enter the
System Contact
.
4.
Enter the
System Location
.
5.
Verify the
Read Community Name
and change if necessary.
6.
Verify the
Read/Write Community Name
and change if necessary.
7.
Verify the
Trap Community Name
and change if necessary.
8.
Enter the
Trap IP Address
, if it does not automatically appear.
9.
Enter the
Trap IP Port
, if it does not automatically appear.
10.
Enable SNMP Alerts
if necessary. Set which alerts you need to receive. See “Setting Alerts”
for more information.
11.
Click
Submit
when you are finished.
12.
Click the
Protocols
tab.
13.
Click
Save Re-init Network
(on the
Protocols
tab) before any changes take effect. Even
though you submitted your changes on the previous screen, they do not take effect until you
click
Save Re-init Network
. This process takes a few minutes.
Summary of Contents for ADTP1 MonarchNet2
