18
Installation
Fitting the Extrusion End Caps
Firmly press the extrusion end caps
into place at both ends of the extrusion.
Adjusting the Vertical Hood Position
The vertical position of the hood must be adjusted to centralise it with
the camera lens.
Moulded Hoods and Extra Wide Folding Hood
1.
Loosen the two side clamp screws to adjust the position of the
hood on the rods.
2.
Adjust the vertical position of the hood to centralise it with the
camera lens and fully re-tighten the clamp screws.
Adjusting the Prompter Assembly Position
The horizontal position of the prompter assembly must be adjusted to
optimise its position relative to the camera lens.
MT-BLACK Mounting Plate Adjustment
1.
Loosen the twist locks on the telescopic rods and move the
prompter assembly back until the hood overlaps the camera lens.
2.
Tighten the twist locks to secure the assembly.
WARNING!
When the hood has been installed, the supplied
extrusion end caps must be fitted to protect against
personal injury.
