Autonics TM Series, User Manual

Page: 85 / 98

6 Parameter Settings and Functions
© Copyright Reserved Autonics Co., Ltd. 85
6.6.2 Run/Stop

Users may run or stop control output by force while in Run mode.

The STOP command stops the control output. Alarm output, other than control output,
maintains the values as set in the alarm output setting at the point of STOP.

This feature can be enabled by configuring parameters. The digital input terminals
(DI-1 and DI-2) can be assigned to the run/stop feature.

Modifications on RUN/STOP are allowed even when in open
state. The STOP status will remain in effect after shutting down
the controller and powering it back on.

When STOP is in effect, MV based on the control output at the
point of STOP (Stop.MV) is displayed, and continues to be
displayed even if a sensor break occurs.

When restarting after STOP, the initial MV is the MV at the end
point.

The run/stop setting remains in effect after turning power back
on.
6.6.2.1 Control Output Upon STOP
This sets the control output value upon a STOP. With ON/OFF control, select between 0.0
(OFF) and 100.0 (ON). In PID control, you can directly choose MV within a range of 0.0 to
100.0.
Group
Preceding
Condition
Parame
ter
Range
Factory
Default
Unit
Control
Setting
Group
Heating,
Cooling
PID
Stop MV
0.0 ~ 100.0
0.0
%
ON/OFF 0.0 (OFF)/100.0 (ON)
Heating
and
Cooling
PID
-100.0 (Cool) to 100.0
(Heat)
0.0
ON/OFF
-100.0 (Cool ON)/0.0
(OFF)/100.0 (Heat ON)
When set to STOP, the preset MV is used for output ignoring the MVs
from ON/OFF control and PID control.