How to Use Your Operator
Safety Beam option
A Safety Beam Kit must be fitted to this operator.
When this Kit is fitted, the operation of this device is
•
such that if an object (i.e. car, child, etc.) blocks the
Safety Beam, then the garage door opener will not
close the door automatically.
When the Safety Beam is fitted but not operating
•
correctly, then the door once opened automatically,
will not close automatically. The door may be closed
by reverting to manual operation – see Manual
Operation.
Auto Close option
To have the Auto Close option you must also have a Safety
Infra-Red Beam fitted and functioning. To enable the Auto
close function remove the back cover from the opener and
place the AUTO-CLOSE jumper near the right hand side
LED light module.
When this option is selected the garage door operator will
attempt to close the door automatically 30 seconds after
opening.
If the Safety Infra-Red Beam is interrupted whilst the door
is closing (e.g. by a person walking through the doorway),
the door will reverse to the fully open position.
If the door does not close automatically, you may close the
door using the Manual Operation.
Courtesy Light
The Courtesy Light will illuminate for approximately 3
minutes each time the door is operated automatically.
Spare buttons of multi-channel remote control transmitters
can be programmed to turn the light on and off by remote
control.
See
Step 19.2
for more information.
Auxiliary output
This function allows the operator to operate other devices
such as external lights, or an alarm system.
To use this function, a spare button of a remote control
transmitter must be programmed to operate the Auxiliary
Output feature.
See
Step 19.4
for more information.
Vacation Mode
The radio receiver of the garage door operator can be
turned off using a remote control transmitter to activate the
Vacation Mode facility. Whilst in vacation mode the operator
will not respond to any remote control transmitter.
To activate the Vacation Mode facility, see
Step 19.3
.
NoTE:
Program only one button to control “Vacation Mode”.
This will reduce the possibility of accidental activation of
this feature.
Pet Mode
A remote control transmitter can be programmed to open
the door partially to allow pet access to the garage.
To activate “Pet Mode” press the transmitter button that
has been programmed for “Pet Mode”. The door will open
partially. Pressing the button again will return the door to
the closed position.
See
Step 19.5
for more information.
Service
While the door operator does not require regular servicing,
to function correctly the door must be in good operating
condition. As a reminder the PA1000 has a built in
maintenance counter. This counter has a factory default of
3000 cycles, which is the recommended service interval.
When this counter expires the yellow SERVICE LED will light
up and opener beep three times at the start of each cycle.
In addition the courtesy light will flash and the operator
beeps five times at the end of open cycle (when the door
is fully open).
These warning signals will self extinguish after 30 cycles.
When this service counter is triggered it is strongly
recommended you contact your garage door dealer to
arrange a door service.
However, if you choose not to have your door serviced the
counter can be reset simply by pressing the LIMIT SET
button.
PA1000
Instruction Manual (Instructions d’installation)
28
