Mounting Door Bracket and Arms
Step 8 - Alternative Mounting Option
The operator can be fastened to the roof by drilling a hole
in the centre of the C-Rail and driving a bolt through it into
structural timber support. The height of bolt head must not
exceed 0.24” (6mm) (
fig.14
).
Mounting door bracket and arms
Step 9 - Mounting Door Bracket
The door bracket comes in two parts. The bottom plate with
two mounting holes is used on its own for any one piece
doors. The top plate is placed over the bottom plate and
uses 4 mounting holes for extra strength. This is used on
sectional doors (
fig.15
).
Mount the door bracket to the centre line of the door, 1/3
panel down (
fig.15
) using M6 or equivalent screws (not
supplied) alternatively it can be welded on steel doors.
NoTE:
As various types of doors exist, if in doubt about the
strength of the door, reinforcement may need to be added
to the frame of the door panel where necessary. Damage
to the door panel may occur if the bracket is installed
incorrectly on a panel with insufficient strength. The door
operator warranty does not cover damage caused by the
operator to the door and/or door panel.
Step 14 - Attaching the Arms
Assemble bent and straight arms (as shown in
fig.16
) with
bolts and nuts supplied in accessory pack. Then connect
assembled arm to the door bracket and the trolley by clevis
pin and snap pin. Trolley must be in disengage position.
Always use both the bent and straight arm.
The angle “A“ must not be less than 10 degrees (See
fig.
16
).
Ceiling
Aluminium rail
Shuttle VP2 assembly
Drill hole at centre of
track (recommended
bolt size M6 or M8)
The height
of bolt head
must not
exceed 6 mm
fig.14
fig.15
fig.16
WARNING:
connecting the bent arm other
way around may damage the door.
IMPoRTANT NoTE:
If the manual release
handle is more than 5.91ft (1.8 meters) from
floor level when the operator is installed,
extend the handle to a height less than 5.91ft
(1.8 meters).
Diamond PD
Power Drive
: Instruction Manual
© Copyright 2011
15
PA1000
Instruction Manual (Instructions d’installation)
