Coding Transmitters
Step 19 - Setting Transmitters Codes
The garage door operator can only operate from remote
control transmitters that have been programmed into the
opener’s receiver. The receiver needs to learn the codes
of any remote control transmitter that will be used with the
operator. Up to 14 codes can be stored in the receivers
memory.
19.1 - Storing the Transmitters Code (Fig.28)
Make sure that the battery is inserted in the
1.
handheld (or wall) transmitter.
Press the CODE SET button on the operator, the
2.
CODE SET LED will illuminate to indicate that the
opener is in Code Learn mode. If a valid code is
not stored within 15 seconds the opener will exit
Code Learn.
Press the transmitter button (one of four) that you want
3.
to control the door for two seconds. The CODE SET LED
will begin to flash.
Press and release the same transmitter button again.
4.
The CODE SET LED will illuminate for one second and
then go out.
The transmitter is now coded to operate the door. Press
5.
that button to test.
19.2 - Setting the Transmitter to Operate the
Courtesy Light (Fig.29)
Although the courtesy light comes on with each operation
of the operator, it may also be controlled (ON/OFF) by a
transmitter without operating the door.
Press CODE SET button twice. The CODE SET LED
1.
will start illuminate and the courtesy light will turn
on to indicate that the light code learning is active.
Choose a transmitter button, which is not already
2.
coded into the receiver. Press this button for two
seconds and CODE SET LED will begin to flash.
Press the same transmitter button again. The CODE
3.
SET LED will illuminate for one second and then
go out.
The transmitter is now coded to operate the light.
4.
Press that button to test.
Press Code set
button once
Select one of the four
buttons that you wish to
use to control the door
Press Code set
Button twice
Select one of the
four buttons (not
programmed yet)
that you wish to
use to control the
Courtesy Light
fig.28
fig.29
Transmitters Compliance Statement
Transmitters comply with all united States and Canadian legal requirements as of the date
of manufacture. To comply with fCC Part 15 and or RSS 210 of Industry Canada (IC) rules,
adjustment or modifications of this receiver and / or transmitter are prohibited, except for
changing the code setting or replacing the battery. ThERE ARE No oThER uSER SERVICEABLE
PARTS. Tested to Comply with fCC Standard foR hoME oR offICE uSE. operation is subject
to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Diamond PD
Power Drive
: Instruction Manual
© Copyright 2011
21
PA1000
Instruction Manual (Instructions d’installation)
