AUTOFLAME Mini Mk8 M.M., Installation And Commissioning Manual

Page: 81 / 125

81
3.6 Gas/ Air Pressure Commission
燃气
/
空气压力调试
To re-commission the gas pressure sensor, go to Commission Mode and press . The
M.M. will then run through the points to store the gas pressure values.
要重新调试燃气压力感应器，操作者需要进入调试模式并按下 按钮。控制模块将
浏览各设定位和保存燃气压力数值。
If the VPS is optioned on, the unit will run through this process. The M.M will go from Low Fire to
High Fire and store the gas pressure values along the curve. Once these values are stored, the upper
and lower offset limits will be adjusted to the new commissioned gas pressure values.
当系统启用了
VPS
（阀门校验系统），控制模块要执行本步骤。控制模块将从低火位到高火位
浏览燃烧曲线和保存各燃气压力数值。在保存好这些数值后，系统将根据新的燃料压力调试数
值来调节最高补偿值极限和最低补偿值极限。
If the burner turns off during the gas/air pressure commission, the gas/air pressure commission
process with be restarted. This ensures that the M.M. does not run with an incomplete set of gas/air
pressure readings.
如果燃烧器在燃气
/
空气压力调试期间关闭，燃气
/
空气压力调试将重新开始。这是为了确保在
控制模块运行时燃气
/
空气压力读数的完整。
Figure 3.6.i Gas Sensor – Low Fire
燃气感应器
–
低火位
To commission the air pressure sensor, in Commission Mode screen press to
commission the air pressure sensor.