AUTOFLAME Mini Mk8 M.M., Installation And Commissioning Manual

Page: 10 / 125

10
79 100mA
仅用于驱动继电器
/
灯
–
切换至中性
120V Unit:
120V
设备
Outputs Terminal 57 250mA Must be connected through contactor Max Load 5A
输出 端口
57 250mA
必须通过接触器连接，最大荷载
5A
58 250mA Must be connected through contactor
58 250mA
必须通过接触器连接
59 2A 0.6 power factor
59 2A 0.6
功率因数
60 2A 0.6 power factor
60 2A 0.6
功率因数
61 2A 0.6 power factor
61 2A 0.6
功率因数
62 2A 0.6 power factor
62 2A 0.6
功率因数
63 2A 0.6 power factor
63 2A 0.6
功率因数
78 100mA To drive relay only – switched neutral
78 100mA
仅用于驱动继电器
–
切换至中性
79 100mA To drive relay/lamp only – switched neutral
79 100mA
仅用于驱动继电器
/
灯
–
切换至中性
Note:
注意：
1. The high and low voltage connections are not safe to touch. Protection against electric shock is
provided by correct installation.
CAUTION – ELECTRIC SHOCK HAZARD.
用手触摸高压和低压连接是危险行为。正确安装电气设备可以防止触电事故。警告：触电危
险。
2. Control voltage cabling should be maximum 10m, screened (if not screened then less than 1m,
however servomotors can be unscreened up to 10m)
控制电压电缆的最大长度应为
10m
，经屏蔽（若未屏蔽应短至
1
米）；伺服马达的未屏蔽电缆
最大长度可为
10m
。
3. Any cabling over 10m must have additional surge protection.
所有超过
10m
的电缆必须配备电涌保护。
4. Low voltage cables should be screened cable as specified in section 1.3.3.
低压电缆应符合章节
1.3.3
规定的经屏蔽电缆。
5. The burner ‘High Limit Stat’ must be a manual reset type.
燃烧器的“上限启停控制器”必须为手动复位型。
Note: There is a lid (back plate) fitted onto the back of the Mini Mk8 M.M. with a Warning label to
prevent any unauthorised fuse replacements.
注意：在
MK8
微型控制模块背部装有一个盖板。盖板上的标识明确指出更换保险丝操作前必需
获得授权。