equipment det
ails
166
equipment det
ails
167
oMnISTEP DoUBLE STEP
operation
Press the “step out” key to bring the step out
until it reaches the end of its run or comes up
against an obstacle. The step does not come
out if the engine is running. Press the “step in”
key to take the step back until it reaches the
end of its run or comes up against an obstacle.
The step goes back in automatically when the
engine is running. In this situation the buzzer
sounds until the step is fully closed.
never mount the step if retracted or if not
fully extended
Maintenance
Dirt and frost can prevent the step from
operating properly. In this case the moving
parts should be cleaned or defrosted.
All points of movement are layered in
maintenance-free bearings.
In case of electrical break down
If the step does not retract by motor:
-
Loosen the square connection according
to fig. 4 (actions 1, 2 and 3), push the
footboard in (4) and tie it to the frame
(fig. 5).
Current drawn
-
7 A. When fully extended or retracted:
19 A
fig. 2 Connection
fig. 3
fig. 4
fig. 5
The free standing table legs have a positive
locking mechanism. Care must be taken to
ensure that, when folded, the leg which is
closed first locks into the second position.
When engaging legs in down position the
mechanism must be positively locked down.
CAUTIon! When erecting the free
standing table, be careful to avoid
trapping fingers.
Table Storage
Tables stored in the table storage
compartment must be securely clipped into
place whilst in transit.
To avoid damage care must be taken when
removing tables from their stored position.
Care of laminate tops, tables, furniture
and doors
Do noT
use abrasives, chemically treated
cloths or aggressive detergents as these may
cause damage.
Do noT
place hot objects on laminated
surfaces i.e. tops, tables. Any temperatures
70°C and over will cause permanent damage.
Clean worktop surfaces, furniture and door
fascias with a soft, slightly damp cloth, dry off
with a soft cloth.
Shower
When using the shower, always ensure that
the shower door is fully closed thus avoiding
water spray on unprotected areas.
12V READInG LAMP
WARNING: 12v reading/spotlamps generate
high temperatures when in use, the body, lens/
bulb may become very hot.
NEVER make directional adjustment in the
direction of flammable materials i.e. curtains,
nets or blinds.
oMnISTEP SLIDE-oUT STEP
operation
Press the “step out” key to bring the step out
until it reaches the end of its run or comes up
against an obstacle. The step does not come
out if the engine is running. Press the “step in”
key to take the step back until it reaches the
end of its run or comes up against an obstacle.
The step goes back in automatically when the
engine is running. In this situation the buzzer
sounds until the step is fully closed.
Maintenance
Dirt and frost can prevent the step from
operating properly. In this case the rails and
moving parts should be cleaned or defrosted.
In case of electric break down
If the step does not retract by the motor
-
Remove the front plate of the step. (Fig. 1)
-
Remove the connection between the
footboard and the arms (with screwdriver
and wrench S10). (Fig. 2)
-
Slide out the footboard.
-
Reinstall the front plate.
Current drawn
-
Working current: 5 A
-
Blocking current, when fully extended or
retracted: 14 A
tables, reading lamp and omnisteps
fig. 1 front plate
