equipment det
ails
136
equipment det
ails
137
DEfRoSTInG
As time goes by, frost builds up on the fins.
When the layer of frost is about 3mm thick,
the refrigerator should be defrosted.
1. Switch off the refrigerator (see Switching
Off section).
2. Remove the ice cube tray and food.
3. Leave the refrigerator door open.
4. After defrosting (freezer compartment and
fins free of frost), wipe the cabinet dry
with a cloth.
5. Use a cloth to mop up the water from the
freezer compartment.
6. Switch the refrigerator back on again.
Warning: The layer of ice must never be
removed forcibly, nor may defrosting be
accelerated using a heat source.
Note: Water thawing in the main compartment
of the refrigerator runs into an appropriate
container at the back of the refrigerator. From
there, the water evaporates.
PoSITIonInG THE SToRAGE RACK
Dismantling:
1. Loosen the front and back securing brackets.
2. Move the storage rack to the left and
remove it.
To fit the storage rack, the reverse order applies.
DooR LoCKInG
open
Park-position/vent-position
Close
SWITCHInG off
1. Set energy selector switch (A) to position
‘0’ (OFF). The appliance is now fully
switched off.
2. Secure the door open by means of the
door stop. The door will be slightly ajar.
This is to prevent mould from forming
inside the appliance.
A
4. Set the main switch (A) to ‘on’.
The ignition starts again.
If after about 30 seconds the operating display
(C) starts flashing red again, the gas fault has
not been cleared (e.g. air in the gas pipe).
5. Briefly switch the refrigerator off and then
on again using main switch (A).
To remove air from the gas pipes, repeat
this procedure 3-4 times.
If these actions do not help, please call an
authorised Dometic Service Centre.
Additional functions
(RM 7xx5 L - models only)
• Temperature setting display (D) with 4
LED to indicate the selected temperature
(MIN - MAX)
• LED - dimmer (E) for adjusting the
brightness of the display-LED (only
accessible when door opens)
E
D
E
Underneath the fascia is a knurled knob for
adjusting the brightness (see item E above).
Temperature setting cooling compartment
As shown, you are able to regulate the
temperature of the cooling compartment, if
necessary, by turning rotary knob (B).
The cooling unit’s performance is influenced by
ambient temperatures.
B
Medium
setting
Tip: Please select the medium setting for
ambient temperatures b15°C and
+25°C. The unit operates within its
optimum performance range.
SToRInG fooD
• Switch the refrigerator on approximately
12 hours before filling it.
• Always store food in sealed containers,
aluminium foil or similar.
• Never put hot food into the refrigerator,
always let it cool down first.
• Products that could emit volatile,
flammable gases must not be stored in the
refrigerator.
• Store quickly perishable foods directly next
to the cooling fins.
The freezer compartment is suitable for
making ice cubes and for short-term storage
of frozen food. It is not suitable as a means of
freezing foods.
MAKInG ICE CUBES
Ice cubes are best frozen overnight. At night,
the refrigerator has less work to do and the
unit has more reserves.
1. Fill the ice cube tray with drinking water.
Only use drinking water!
2. Place the ice cube tray in the
freezer compartment.
