Assembly Instructions
•
Spindle Drive SP -24 V / 230 V
9000002601.doc
Page
27
of
34
Assembly procedure
for outward-opening windows
in roof & facade area
Suspend the drive in casem. bracket
- insert pin
- the pin needs to slot in securely
(Clicking sound coming)
F1
Suspend the drive in cas. bracket
- screw in pin
- secure pin from loosening itself
with glue
F10.6
Connect drive with casement bracket
- adjust eyebolt if necessary (see page 22)
- adjust contact pressure of casement by regulating the eyebolt and by sliding
the drive in the bracket
- make sure that the drive shut off via end switch (see page 22)
Route cable according to on-site situation
- the cable must adapt to pivoting angle of the drive (lay with strap)
- Cable must be protected against damage such as shearing off, kinking, cracking
on frame or bar (waler)
Cable junction box
for cable extension
Ways to extend connecting cable
- make sure the voltage loss is no more
than 2 V
- max. extension up to 10 m
Install site-supplied junction box and
carry out electrical connection
- close to the window – must be easily
accessible later on
- Avoid any installation area with large
temperature differences, risk of water
condensation
- Observe maximum cable length of
drives, standard length approx. 1 m
- Ensure that a later removal of the
connection cable is possible
(see pages 29 & 30)
17
