Aumuller FV1, Assembly And Commissioning Instructions

Page: 11 / 36

11
Assembly Instruction
FV1 / FV3 / FV4
Tools required
• marker,
• grains,
• hammer,
• knife,
• screwdriver (cross, Torx),
• hexagonal wrench,
• torque wrench,
• power drill,
• threadlock adhesive,
• possibly a tool for blind rivet nuts.
The number of locking points depends on:
• object-specific requirements
• processing guidelines and authorized ranges of
application of the manufacturer
• EN
12102-2 NRWG (depending of profile group
and wind load classification
WL
)
• EN 12207 Air permeability
• EN 12208 Driving rain tightness
• EN 12210 Resistance to wind load
• EN 1627
Burglar resistance
• EN 14351-1 Window or door standard
• DIN 1991-1-3 Snow loads
• DIN 1991-1-4 Wind loads
Locking points are centers / axes of the following com-
ponents: casement hinges / stays (
BD
), sealing points of
the locking system, application points of directly actuating
drives (force transmission axes at 90° to the casement
profile, with closed window).
Drives used in SHEV mounting devices such as: RWA 1000,
RWA 1050, RWA 1100 are not included in the locking points.
Free profile lengths are effective distances between two
locking points. Corner and edge distances shall be cal-
culated as straight lines.
Only the worst case with secured values and
application ranges must serve as a basis.
FL
RA
HSK
free profile length free
free profile length
pr
ofile length
free length
fr
ee pr
ofile
pr
ofile length
fr
ee pr
ofile
length
NSK
BD
Locking point
FAB
FA
H
d
etermination oF Locking points
Free profile lengths
between two locking points
Free profile length for Ix
4
-values
of the window casement profiles
20-34 cm
4
35-50 cm
4
51-55 cm
4
56-99 cm
4
Static wind slipstr
eam loads
on the SHEV - accor
ding to EN 12101-2.
WL 1000
1300 mm 1500 mm 1700 mm 1900 mm
WL 1500
1200 mm 1400 mm 1600 mm 1800 mm
WL 2000
1100 mm 1275 mm 1450 mm 1650 mm
WL 2500
900 mm 1025 mm 1150 mm 1275 mm
WL 3000
800 mm 900 mm 1000 mm 1100 mm
Values apply only for a
umüller
ferralux NRWG.
n
ote
The number of locking points or the
free profile length between two locking
points are described into the respective
system documents of the window profile.
This information must be adhered.
The requirements for the tightness of the
windows according to EN 14359-1 must
be observed!
P
reParing assembly
03