3
CD2610
Radio Fuse
+12V Accessory
Gray/Black (-)
Gris / Negro (-)
Gris / Noir (-)
Gray / Gris / Gris (+)
10
White/Black (-)
Blanco/Negro (-)
Blanc/Noir (-)
White / Blanco / Blanc (+)
Violet / Violeta / Violet (+)
1
3
2
+
4
9
11
12
Green / Verde / Vert (+)
Green/Black (-)
Verde/Negro (-)
Vert/Noir (-)
Violet/Black (-)
Violeta/Negro (-)
Violet/Noir (-)
Gray
Yellow
7
10A
Yellow
Dark Blue
Black
8
Red
1 Amp
Fuse
6
5
Wiring
Wiring with a Wiring Adapter (Purchased Separately)
Connect Wires
You can make all these connections without even being in the vehicle.
1.
Splice or crimp wires.
2.
Attach wiring adapter to car wiring harness.
Wiring Diagram / Color Codes
1.
Power Antenna (dark blue wire) - Connect to power antenna or amplifier. If not used, tape
bare end of wire.
2.
Accessory/Ignition (red wire) - Connect to existing radio wire or radio fuse.
3.
Ground (black wire) - Connect to ground terminal or clean, unpainted part of chassis.
4.
Memory/Battery (yellow wire) - Connect to battery or 12 volt power source that is always
live. The radio will not work if this wire is not connected.
5.
Antenna Connector - Connect the antenna plug from the existing antenna cable (some
vehicles require an adaptor).
6.
CD Changer - Use this 8-pin DIN socket to connect an optional CD Changer.
7.
Auxiliary Input Cable (yellow RCA cables) - Connect line in for auxiliary input devices (CD
player, etc.).
8.
Outputs to Amplifier (gray RCA cables) - Connect line out for optional external amplifiers.
The red connector is for the right and the white connector is for the left.
9.
Left Front Speaker
10. Right Front Speaker
11.
Left Rear Spearker
12. Right Rear Speaker
NOTE: The amplifiers in this radio are only designed for use with four speakers. Never
combine (bridge) outputs for use with two speakers. Never ground negative speaker
leads to chassis ground. Failure to wire exactly as shown may cause electrical damage
to the radio.
Fuses
When replacing a fuse, make sure the new fuse is the correct type and amperage. Using an
incorrect fuse could damage the radio. The CD2610 uses one 15 amp fuse located below the
wiring connector (15 amp fast blow ATO).
Reconnect Battery
When wiring is complete, reconnect the battery negative terminal.
Technical Assistance
If you require assistance, contact Technical Support at 1-800-323-4815 from 8:30am to 7:00pm
EST Monday through Friday and from 9:00am to 5:00pm EST on Saturday.
Wiring
Cableado
Câblage