Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Removing
- -> Use flat screwdriver to press in retainer tab -1- and prise out door safety light/entry light -2-.
- Unplug connector -3-.
- -> If fitted, carefully prise off cover at door safety light -arrow-.
- Take bulb on back of door safety light/entry light out of holder.
Installing
Install in reverse order, paying attention to the following:
- If applicable, attach cover at door safety light.
- Plug in connector.
- Insert door safety light/entry light in opening and engage on opposite side.
4 - Servicing lock cylinder heater
4.1 - Servicing lock cylinder heater
Attention:
◆ Disconnect battery earth strap before working on electrical system.
◆ On vehicles fitted with telematics system, activate telematics control-unit service mode before disconnecting
battery.=>Radio, Telephone, Navigation; Repair Group 91
- Heed (if necessary obtain) code for vehicles with encoded radio/radio navigation system (RNS).
- Disconnect battery earth strap with ignition switched off.
Note:
Action to be taken after re-connecting power supply => Page
7
.
4.2 - Removing and installing lock cylinder heater control unit
Lock cylinder heater control unit is located at upper cross member in driver's door.
Audi A3 1997 ➤
Electrical system - Edition 10.2003
3.14 - Removing and installing door safety light and entry light
185