audemat DIGIPLEXER 246, User Manual

Page: 6 / 93

Digiplexer 246 v2.5.x User Manual – 11/2010
Page 6
Head Office : Parc d’activites Kennedy - 20, avenue Neil Armstrong – F-33700 Bordeaux-Merignac (France)
Tel +33 (0)5 57 928 928 – Fax +33 (0)5 57 928 929 –
contact@audemat.com – www.audemat.com
7. The device should only be operated on a stable electrical network. If the electrical
network is not stable, a power conditioner, such as a UPS, must be used.
8. Any maintenance, adjustment or repair must be carried out by qualified staff.
¾ Caution: LITHIUM BATTERIES
If the battery is not correctly replaced, there will be a risk of explosion.
Only replace it with a battery of the same type. Contact Audemat before attempting to use
another type.
Do not throw away used batteries; send them back to us.
1.3.
Licenses and options
a) Software options:
¾ Full RDS :
ƒ Configure up to 10 DSN (on 2 in basic RDS),
ƒ Manage EON (up to 9 EON in addition to the main PSN per DSN),
ƒ Manage SLC,
ƒ Configure ODA.
¾ Audio Backup : additional source (file or MP3 stream in Shoutcast format) that will
replace the analog or AES inputs in case they fail.
Note: sampling frequency for audio files must be 48 kHz
¾ Advanced Audio Backup : creation and management of embedded playlists that will
replace the analog or AES inputs in case they fail.
¾ MasterView : with this application, visualize and control your site in custom views.
¾ 1 to 2-band upgrade .
¾ 2 to 4-band upgrade .
Please see Appendix A of this manual for upgrading procedures.
b) Hardware options:
¾ Input / Output modules:
•
Digital inputs : this module provides 16 digital inputs on a female SUB-D 25.
•
Relay outputs : this module provides 8 relay closures on a male SUB-D 25.
•
Analog inputs : this module provides 8 analog inputs on a female SUB-D 25.
Five slots are available on the Digiplexer 246, to set up to 4 digital input modules, up to 5
relay output modules and up to 1 analog input module.
¾ Redundant power supply : in case one power supply fails, the other one takes over, thus
allowing the unit to operate with no interruption. Also includes a UPS (Uninterruptible
Power Supply) to make it possible to send an alarm in case of complete power failure.
¾ FM Mod 0.5, 20 or 100W amplifier : transmission and amplification module that
turns the unit into a transmitter.
Please see Appendix B of this manual for input / output configuration.