CHAPTER 4: TRANSCODING APPLICATION
VersAtive
®
Pro Enhanced – Operation Manual
4-3
•
The programs that are read from the PMT table on that stream will be displayed in the Program Selection window,
9. Click to select a single
Program
. PID level selection is not supported. Unwanted audio PIDs may be disabled later
at the Publishing stage.
10. Use the Arrow controls to move programs both ways (or
Drag and Drop
a single program onto the Resource until a
green check mark appears).
11. The program PIDs are added to the Resource. PIDs may be removed by clicking
RESET
.
12. When finished with the selection, click
Add
to add this program and create the Resource.
13. The Program is added to the Resource, Figure 4-5, and shown in the Tree View under the Device with the included
SPTS Incoming stream PIDs detailed in the adjacent Pane View. This is automatically saved.
14. The ‘Preview ON’ tick box is selected by default. Untick the box to disable Preview for this resource only and click
Save
if a change was made.
NOTE:
The Preview function requires a small amount of Device CPU cycles. If the Device is
running close to 100% CPU utilization as witnessed by the Device Monitoring page, see
Monitoring the Device” on page 6-1,
disabling preview can help with that condition. Each
Resource Preview function must be disabled individually so click each active resource in the Tree
View to access this control.
9
10
11
12
Figure 4-4: Arrow Controls Move Program to Resource
13
14
Figure 4-5: Resource Added to Tree View
