30
Selecting [ INST/EFFECT ] data
Instrument and effect parameters
In firmware version 2.00 new functions to enable the selection of factory library Instruments and Effects have been
added.
In Instrument edit mode, press either the [1 PITCH]or [2 DECAY] button repeatedly until the top line of the LCD display
shows:
IXX <- LdP2B.Inst
Follow the same procedure in Effect edit mode until the top line of the LCD display shows:
EXX <- LdP2B.Fx
Example procedures for selecting I22 (Instrument 22) and E22 (Effect 22) are described below:
You can select and change either an Instrument (P01: Harmo Drum) or Effect (P01: Harmo D.Rev) displayed on the
lower line of the LCD (original) by rotating the encoder clockwise. This selects and loads the instrument or effect into a
temporary buffer. If you rotate the encode counter clockwise you access the Factory library presets and can select from
the range of factory instruments or factory effects.
After making your Instrument (I22) or Effect (E22) selection, pushing in the encoder wheel will copy the Instrument
or Effect into a temporary memory location and the sound will change. This is an effective way to try out different
combinations of Instruments and Effects. In keeping with other parameter editing operations, after pressing in the
encoder wheel to make a selection, the FNC button will light up. If you press the FNC button, the display prompts with:
Both the encoder wheel and FNC button will flash. Press the FNC button if you do not wish to cancel the edit, or press the
encoder wheel to cancel the edit and return to the initial state.
The table lists the Instrument factory library data and Effect factory library data that are available for selection.