ASTi Synapse Voisus Server Manual (Ver. 1, Rev. F1)
12
Copyright © 2012 Advanced Simulation Technology inc.
2.2.4. ACE-RIU Installation
One ACE-RIU is required for each Synapse Voisus Server to provide system synchronization.
Important
: The ACE-RIU in the Voisus Server configuration is not used to produce audio. Do not
connect headsets to the device.
Refer to Figure 2 for top level system installation guidance.
Advanced Simulation Technology, Inc.
CHAN A
CHAN B
CHAN C
CHAN D
Figure 5: ACE-RIU Front Panel
Serial Ports
A
B
Status
Power
+15VDC
1 2 3 4
ACENet
Figure 6: ACE-RIU Rear Panel
In addition to the ACE-RIU, you will need the following items:
• ACE-RIU Power Supply
• CAT5 or CAT6 cable
Follow these steps to install the ACE-RIUs:
1. Connect the ACE-RIU Ethernet port (ACENet) to Eth1 on the Telestra, using a CAT5
cross-over cable or a switch and CAT5 patch cable.
2. Connect to a furnished 15 volt power supply.
IMPORTANT
: Use only the ASTi furnished
power supplies for this purpose. Use of other power supplies may result in equipment
damage not covered by the product warranty or degraded product performance.
