‐
30
‐
12‐1015 rev‐B
User’s Manual Version 14.12
7.3 Charging Test
This test is to check the MAX and MIN charging voltages output of the
alternator at 3000 RPM without load and 2000 RPM with all loads ON. With this
test you can determine the alternator’s condition when in reference with the
vehicle’s Service Manual.
Starts with No load testing at 3,000 RPM
1. With engine OFF, place
the vehicle transmission in NEUTRAL for Manual
and PARK for Automatic and apply the parking brake.
2. Attach the Analyser clips onto the battery terminal posts and it will power up
and lights up the LCD display screen as shown (Fig.45). Press key
and the display will show as Fig. 46 below.
3. Select [Charging Test] and it will proceed to the display below: (Fig. 47)
Start the engine and then press key again and the screen will
prompt you as shown below (Fig. 48).
Fig.47
No Load Test
Start the car engine
and keeps it running.
[Enter] to proceed
Select Menu
23/12/2014 16:48
New Test
Continue Test
Stored Results
Setup Menu
Select Test
Battery Test
Grounding Test
Starter Test
Alternator Test
[Enter] to proceed
Fig.45
Fig.46
