‐
14
‐
12‐1015 rev‐B
User’s Manual Version 14.12
5.7 Erase Memory
This Analyser is able to save up to 250 test results in its memory. In event that you
need to clear all the results in the memory to make for new ones after they had
been backed up into the PC, then select this item [Erase Memory] and press
key to enter into it. Once entered, the display will show as in Fig.13 below:
To erase the memory, now press
key and it will proceed with the erasure as
shown in Fig. 14 above. After completion, it will return to the setup menu (Fig.11)
6.0 Battery Test
Performing Battery Test whilst it is still in the car
Vehicle that was running has to have its engine OFF first and then switch ON the
headlights for 30 seconds to remove the surface charge. After the headlights had
switched OFF, let the battery rest for at least 1 minute to recover before testing
commences.
The car engine and all other accessory loads must be
OFF
during test in order to
have accurate results. When attaching the analyser clips, make sure that the
battery posts were not oxidized or badly corroded. Clean them first before
clamping to it. Do not clamp onto the steel bolts directly which may give inaccurate
and inconsistent results.
Fig. 13
Erase memory
Erase Memory
[Enter] to proceed
[Exit] to quit.
Erase memory
Erase Memory
[Enter] to proceed
[Exit] to quit.
Fig. 14
